For allen wrench information see wrench size used to tighten a sub zero handle.
Tighten door handle sub zero.
Remove the handle by removing the set screws from the underside of both handle standoffs.
Don t over tighten as they strip easily because they are so small.
It is between.
Both l shaped and flat allan wrenches can be used.
Tighten the handle.
Contact factory certified service to schedule an appointment for repair.
Loosen the screw place the handle back on flush against the door surface and tighten the screw finger tight.
If the end caps are tight to the door and the handle is loose service is needed.
There is no direct metric equivalent for a 3 32 allen wrench.
A small amount of blue loctite may also prevent the mounting stud from loosening in the.
A 3 32 allan wrench is needed to tighten the set screw on a sub zero stainless steel handle.
Use whatever screwdriver or wrench is appropriate to tighten this screw and firm up the doorknob s grip on the spindle.
Remove the screws from the side mounting brackets.
Remove the panel by pulling down and out to release the panel mounting tabs from the drawer.
There should be a small set screw on the inside of the handle opposite side of the picture.
Designer formerly integrated series remove the molding trim from the door or drawer.
Remove the molding trim from the hinge side of unit or bottom of drawer.
Remove the molding trim from the hinge side of unit or bottom of drawer.
Tighten the handle.
The door must be partially disassembled to tighten the handle.
Remove the screws from the side mounting brackets.
This is usually driven with a small allen key.
Once the handle and standoffs are removed from the door tighten the standoff mounting stud with a flat head screwdriver.
The handle on a wolf range or wall oven should not be loose.
Remove the magnetic caps covering the side mounting brackets.
See also sub zero 700 series panel removal.
Remove the magnetic caps covering the side mounting brackets.
Tighten the handle screws from the back side.
Remove the panel by pulling down and out to release the panel mounting tabs from the drawer.
Refer to the images above.